Search results for "Mechanical components"
showing 6 items of 6 documents
B-Scan image analysis for position and shape defect definition in plates
2016
Definition of size, shape and location of defects into a mechanical component is of extreme importance in the manufacturing industry in general and particularly in high-tech applications, and in applications that can become dangerous due to the structural failure of mechanical components. In this paper, a laser-UT system has been used to define position and shape of internal defects in aluminum plates. An infrared pulsed laser is used to generate ultrasonic waves in a point of the plate and a CW laser interferometer is used as receiver to acquire the out-of-plane displacements due to the ultrasonic waves in another point of the plate. The method consists of acquiring a B-Scan map on which s…
Electric-Motion in Romania - Overview - Study on Machining Parameters of EV Charging Station Mechanical Components
2016
This paper presents some relevant aspects of charging infrastructure for electric vehicles in Romania. It evidences the charging station and fast charging stations designed and installed by the first Romanian company dedicated 100% to e-mobility, E-Motion Electric. Also, a study on machining (milling) parameters of some mechanical components of electric vehicle (EV) charging station is done and, finally, the regression model for these parameters is determined. This model would be further used for machining process optimization.
Effects of the indentation process on fatigue life of drilled specimens: optimization of the distance between adjacent holes
2016
The generation of permanent compressive stresses around the holes is recognized as a valuable mean to delay the onset and propagation of the defects and to extend the fatigue life of the mechanical components. In the work, a bilateral indentation process, performed on each side of the component, is widely used in order to create a residual circumferential stress field around the area to be drilled and that persists after the drilling operation. In order to evaluate the process parameters and to identify optimal geometric solutions, several static and fatigue tests are conducted on AW 6082-T6 aluminum alloy specimen where two holes are created. In particular, experimental tests on only drill…
Further improvements in the structural analysis of DEMO Divertor Cassette body and design assessment according to RCC-MRx
2019
Abstract This paper presents the enhancements related to the structural analyses of DEMO Divertor in the framework of the EUROfusion Power Plant Physics & Technology (PPPT) program. This activity started two years ago and its preliminary results were published in previous papers. It has been divided in some areas defined by the similarity of the matters they contain: the structural analysis, of utmost importance, has been preceded by a preliminary phase, like the geometry definition or the thermal and the electric-magnetic analysis for loads evaluation; then the structural analysis has been finally confirmed with further evaluations related to excessive deformation or plastic instability. T…
Effects of prolonged walking on neural and mechanical components of stretch responses in the human soleus muscle
2009
After repeated passive stretching, tendinous tissue compliance increases in the human soleus (SOL) muscle–tendon unit. During movement, such changes would have important consequences for neural and mechanical stretch responses. This study examined the existence of such effects in response to a 75 min walking intervention. Eleven healthy subjects walked on a treadmill at 4 km h−1 with a robotic stretch device attached to the left leg. Ultrasonography was used to measure SOL fascicle lengths, and surface EMG activity was recorded in the SOL and tibialis anterior (TA) muscles. Perturbations of 6 deg were imposed at three different measurement intervals: Pre (immediately before the walking inte…
Surface and Thin Film Analysis by Mössbauer Spectroscopy and Related Techniques
1996
The main trend in current high-tech development is miniaturization. This holds for complex electronic devices, such as microprocessors, as well as for coatings, such as Langmuir-Blodgett coatings, optical components, such as fiber couplers, chemical devices, such as microreactors, mechanical components, such as micromotors, and many others. Development and production of components with dimensions in the micron and submicron range require the availability of appropriate analytical tools for chemical, physical, and morphological analyses. In close interaction with the development of microcomponents, many, more and more efficient, analytical methods have been developed, many of which are “surf…